Sticker Fab
StickerFab Special Edition Dark Smoke Carbon Fiber Tail Light Overlays
2017-2021 Toyota 86 / Subaru BRZ
This special edition film takes the original StickerFab overlays to another level. Made in the USA, it's a super premium material with air egress channels for easier installation.
It's not a cheap material to stock so you won't find many companies working with it. The Carbon Fiber type has a unique effect on any lamp it is placed on. It bends light into a unique pattern. Despite being dark, it'll still let light shine through. When the lights are not off, it looks like a black, stealthy carbon fiber pattern.
Sold as a pair. Also fits OLM OE Plus Linear Style Sequential Tail Lights.
Details
Special Edition Dark Smoke Carbon Fiber Tail Light Overlays
This special edition film takes the original StickerFab overlays to another level. Made in the USA, it's a super premium material with air egress channels for easier installation.
It's not a cheap material to stock so you won't find many companies working with it. The carbon fiber type diffuses light in a neat pattern. When the lights are off, it's dark and looks like normal carbon fiber textured patterns.
Sold as a pair. Also fits OLM OE Plus Linear Style Sequential Tail Lights.
Tech Tip Tuesday Installation Video
Installation Instructions
Difficulty 3 of 5
Recommended Tool(s): Heat Gun or Hair Dryer, soapy water
Clean the surface of the tail light. Use soapy water to make installation easier. Place the slightly soapy water on the tail light and the adhesive side of the overlay. Start in the middle of the tail light and apply the film. Use your fingers to squeegee out the water. It is recommended you use your fingers so you do not scratch the material. The heat can be used to allow the material to stretch AND to slightly shrink it when you're not pulling it. Massage out any creases with your fingers. You may have to pull up sections and reapply if many creases begin to appear. Keep working the material until you have 100% coverage. Average time per install is 10 minutes per side. Best to allow the vehicle to remain in the sun for some time and DO NOT POWER WASH for at least 48 hours. Some bubbles and creases may disappear over time and exposure to heat.
