Radium Catch Can Kit PCV Fluid Lock

Radium Engineering PCV-Side Fluid Lock Catch Can Kit

SPECS:

• Designed to fit on the right-side of the engine bay
• PCV-side fluid lock type
• Less oil consumption effectively raises the octane levels
• Cleaner air increases engine performance
• Prevents sludge buildup in the intake 
• Lowers hydrocarbon emissions
• Capacity: 7 fluid ounces
• Height Without Fittings: 5 inches
• Outside Diameter: 2.45 inches

PLATFORM SPECIFICS:

• Strategically located for compatibility with right-hand drive and left-hand drive vehicles
• Some brake line clearances are necessary for RHD installation
• These kits are also compatible with aftermarket forced induction kits
• For mounting, the kits use factory bosses and holes in the vehicle so no cutting, drilling, or permanent modifications are needed to the vehicle 
• This kit does not vent into the atmosphere making this kit emissions and track legal 
• Closed loop systems route clean filtered air back in through the engine to be burned and to promote negative crankcase pressure for optimal performance 
• Closed systems prevent unwanted oil vapors into the cabin 
• This catch can kit runs in line with the 3/8" PCV valve
• When the intake manifold pressure is close to or greater than atmospheric pressure, the PCV "check" valve closes to experience no flow
• The PCV hose will experience "metered" vacuum when the engine is idling, steady-state cruising, and decelerating