Sticker Fab
Sticker Fab 3D Carbon Reverse Lamp Overlay
2020+ A90 Supra
Details
3D Carbon Vinyl Reverse Lamp Overlay
The entire rear diffuser of the GR Supra is a semi gloss, plain finish. These overlays are carefully crafted to cover the reverse / rear fog lamp area and give it a carbon fiber appearance. Sticker Fab is a US based company that has been creating designs for late model vehicles. The black, textured, carbon appearance is a great accent for all colored vehicles.
The design is thoughtful and not only satisfies a need for aesthetic appeal, but is also easier to install on curved surfaces. You don't have to be an expert in wrapping a car to apply these.
Material Details
Dragon Wrap™ Carbon Fiber Film is a 5.6 mil calendered vinyl film featuring a clear repositionable permanent acrylic adhesive on an air-egress liner. This film has excellent dimensional stability, outstanding durability and outdoor performance. This repositionable permanent adhesive offers minimal initial bond growing to permanent bonds that facilitates application of large graphics. The air egress liner also aids in large graphic application.
Lasts up to 5 years outdoors.
Care Details: Concept Carbon Fiber film should be maintained to preserve long term appearance using standard aftercare products designed for textured exterior vinyl surfaces. A commercially available protectant such as Armor All or 303 Aerospace Protectant is recommended. DO NOT use waxes of any type.
Featured on New Products December 2019
Installation Notes
Clean the application area and make sure it is clear of any dirt, debris, and ideally wax. Having a hair dryer or heat gun handy can aide in installation, but we've been able to install this without either in the middle of winter. You want to start with the actual lamp cover with tiny holes for the lights. Then apply with U shaped piece. The last piece is the outer surround and will overlay a little of the U shaped piece. This will give you complete coverage of the area. You can apply a small amount of tension to stretch the material and prevent it from creasing and covering the trim exactly where you want it to. Heat is stretching is really only needed on the very outer piece.
