Sticker Fab

StickerFab Special Edition Dark Smoked Carbon Sidemarker Overlays

2020-2021 Toyota A90 Supra

Was: $19.95
You save:


SKU: A90SMDSCBWe price match!

In Stock

Ships within 24 hours

Sticker Fab has distributed over 20,000 vinyl products in the last few years! This new platform will be a great canvas for their accents and protection items.

This dark smoke CARBON FIBER material will knock out some of the color in your sidemarkers. Please see photos for how much light remains reflected when under direct light.

Sold as a set of four (unique piece for each sidemarker). Pairs well with the tail light overlays (sold separately).

You will earn Reward Points with this Purchase.


Dark Smoke Carbon Fiber Sidermarker Overlays

There's a lot of dark trim on the GR Supra but not so much orange or red. These overlays can help knock out the color with ease. They are made by Sticker Fab who is a US based company that has been creating designs for late model vehicles.

Sold as a set of four (unique piece for each sidemarker). Pairs well with the tail light overlays (sold separately).

Material Details

This material was actually made in the USA. It's high quality, but has a higher associated cost. Since Sticker Fab has precut it to fit the GR Supra, you shouldn't have any problems installing it though.

The dark smoke carbon fiber will allow some light to be reflected back, however it is dark.

Installation Notes

NOTE: The longer sidemarker overlays are for the rear.

Clean the application area and make sure it is clear of any dirt, debris, and ideally wax. Having a hair dryer or heat gun handy can aide in installation, but we've been able to install this without either in the middle of winter. Start at the top of the sidemarker, align the vinyl there and work your way toward the bottom. You can use a wet installation if you want, however this is also not required. When you do not use a wet installation you need to be sure there is absolutely no dirt or it will get stuck in between the sidemarker and vinyl with no way out. The hair dryer or heat gun would be used to dry out the water after install. Just make sure that it is not too hot of air. If it can burn you it is probably too hot for drying out the vinyl.

FTspeed's Carbon Vinyl Overlay Install Video

0 customer reviews

Average rating
(based on 0 reviews)
Ease of Installation
Fit / Quality
Overall Satisfaction

Write Your Own Review

Only registered users can write reviews. Please, log in or register


No questions have been asked about this product.

Upload images for this product