Sticker Fab
Sticker Fab 3D Carbon Volume and Preset Trim
2020+ A90 Supra
Details
Interior Volume and Present Button Trim
After making the steering wheel overlays, Sticker Fab looked for additional spots that could use a little styling. The volume / preset control trim has a nice flat surface and they were able to make an overlay for it.
Material Details
Dragon Wrap™ Carbon Fiber Film is a 5.6 mil calendered vinyl film featuring a clear repositionable permanent acrylic adhesive on an air-egress liner. This film has excellent dimensional stability, outstanding durability and outdoor performance. This repositionable permanent adhesive offers minimal initial bond growing to permanent bonds that facilitates application of large graphics. The air egress liner also aids in large graphic application.
Lasts up to 5 years outdoors.
Care Details: Concept Carbon Fiber film should be maintained to preserve long term appearance using standard aftercare products designed for textured exterior vinyl surfaces. A commercially available protectant such as Armor All or 303 Aerospace Protectant is recommended. DO NOT use waxes of any type.
Installation Notes
Clean the application area and make sure it is clear of any dirt, debris, and/or Armor All. We started with the side opposite the volume control. Make sure the coverage in this corner is the way you like it and work your way to the opposite side. Apply evenly without heat. Use your fingers to press down on the vinyl. If it is pretty cold out, we recommend using a heat gun or hair dryer (don't use too much heat) to activate the adhesive. The adhesive is also pressure activated. All you need is to use your fingers though. We don't recommend a squeegee or anything hard.
