Radium Crankcase Oil Catch Can Kit

An oil catch can is essential on a performance vehicle to protect the engine from elevated levels of crankcase blow-by accumulated from aggressive driving. Excess oil saturated air circulating back into the air intake stream can lead to degraded performance. Unlike many catch cans on the market, this catch can features an integrated oil separator that accelerates oil condensation. This cleans the PCV gasses and reduces the oil build-up on the inside of the intake tract and intake manifold. The stainless steel filtration media is cleanable and reusable.

An oil catch can is essential on a performance vehicle to protect the engine from elevated levels of crankcase blow-by accumulated from aggressive driving. Excess oil saturated air circulating back into the air intake stream can lead to degraded performance.

Unlike many catch cans on the market, this catch can features an integrated oil separator that accelerates oil condensation. This cleans the PCV gasses and reduces the oil build-up on the inside of the intake tract and intake manifold. The stainless steel filtration media is cleanable and reusable.

BENEFITS OF A RADIUM CATCH CAN:

• Effectively raises the octane and increased engine performance from cleaner inlet air
• Prevents oil buildup in the intake or intercooler system walls, throttle body, intake manifold, etc.
• Excessive oil collection can be an indicator of a damaged engine
• Lowers hydrocarbon emissions
• Capacity: 6 fluid ounces
• Height (without fittings): 5 inches
• Outside Diameter: 2.45 inches

MOUNTING LOCATION

Radium engineers have strategically located the catch cans for compatibility with both Right Hand Drive (RHD) and Left Hand Drive (LHD) "86" model variations. Some brake clearance is necessary on RHD installations. Both of these kits are also compatible with all current aftermarket forced induction kits. Mounting is done using factory holes. No cutting, drilling or permanent modification to the vehicle is required.

KIT DETAILS

This does NOT vent to atmosphere (VTA), thus is emissions and track legal. Closed loop systems route clean filtered air back in through the engine to be burned and to promote negative crankcase pressure for optimal performance. Furthermore, closed systems prevent unwanted oil vapors into the cabin.

Each kit includes:

• Radium billet oil catchs can with integrated condenser and dipstick
• Radium laser cut powder coated "86" specific mounting brackets
• Anodized aluminum -8AN hose ends and adapter fittings
• Enough 1/2" PCV rubber hose to mate to custom applications
• Barb hose adapter
• Stainless steel mounting hardware
• Installation instructions

The "Crankcase Vent" kit mounts on the left side of the engine bay. This catch can runs inline with the 1/2" breather port. At low loads it experiences atmospheric pressure, but when the engine is at high load (WOT), this hose will experience vacuum and would normally be drawing unwanted crankcase vapors, unspent fuel, and oil sludge into the air filter intake pipe. If the engine is turbocharged or supercharged and you are finding oil accumulation stuck in the intercooler, this catch can is a necessity as oil will lower the thermal efficiency properties of the heat exchange process.

Optional Accessory

PETCOCK DRAIN KIT

• Anodized -4AN O-ring barbed fitting
• Nylon 1/4" barb mini ball valve
• 6ft high temperature rated 1/4" rubber hose

This kit, sold separately, can be used to remotely drain the catch cans without the need to unscrew the canister body. Dual setup includes two!